2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built Oct 2014 – Dec 2014


1. INSTALL FRONT OIL PUMP OIL SEAL

  1. C295078
    Using SST and a hammer, install a new front oil pump oil seal to the front oil pump body sub-assembly.
    SST
    09350-30020   (09351-32140)

    Oil seal driven in depth:
    -0.2 to 0.2 mm (-0.00787 to 0.00787 in.)

  1. Coat the lip of the front oil pump oil seal with MP grease.


2. INSTALL FRONT OIL PUMP DRIVE GEAR AND DRIVEN GEAR

C191448
  1. Coat the driven gear and drive gear with ATF.

  1. Install the driven gear and drive gear to the oil pump body.


3. INSTALL STATOR SHAFT ASSEMBLY
  1. Place the front oil pump body sub-assembly on the torque converter assembly.

  1. Align the bolt holes of the stator shaft assembly with the bolt holes of the front oil pump body sub-assembly and install the stator shaft assembly to the front oil pump body sub-assembly.

  1. Temporarily install the stator shaft assembly with the 6 bolts.

  1. C191457E01
    Install SST to the oil pump assembly.
    SST
    09350-20015   (09363-20010)

  1. Tighten SST to align the oil pump assembly.

  1. C191458
    Tighten the 6 bolts.

    Torque:
    7.4 N*m{ 75 kgf*cm , 65 in.*lbf }

  1. Remove SST.


4. INSTALL CLUTCH DRUM OIL SEAL RING

  1. C191446
    Coat 2 new clutch drum oil seal rings with ATF.

  1. Connect the ends of the clutch drum oil seal rings and install the clutch drum oil seal rings to the stator shaft assembly.

    HINT:
    After installing the clutch drum oil seal rings, check that they rotate smoothly.


5. INSTALL FRONT OIL PUMP BODY O-RING

  1. C191444
    Coat a new front oil pump body oil seal ring with ATF and install it to the front oil pump body sub-assembly.

    NOTICE:
    Make sure that the oil seal ring is not twisted.

← INSPECTION (Oct 2014 – Dec 2014)PRECAUTION (from Oct 2014) →