2014-2019 Hiace · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT REAR DOOR LOCK ACTUATOR ASSEMBLY LH

  1. B102910E01
    Inspect the slide door lock assembly LH.

    1. Apply battery voltage and check operation of the door lock actuator.

      Standard:
      w/ Power Slide Door 
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 3
      Lock
      Battery positive (+) → Terminal 3
      Battery negative (-) → Terminal 2
      Unlock
      w/o Power Slide Door 
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Lock
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      Unlock

  1. w/ Smart Entry and Start System:
    Check the operation of the door unlock detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      Battery positive (+) → Terminal 1 (*A)
      Battery negative (-) → Terminal 4 (*A)
      Locks
      10 kΩ or higher
      Battery positive (+) → Terminal 1 (*A)
      Battery negative (-) → Terminal 4 (*A)
      Unlocks
      Below 1 Ω

      Text in Illustration 
      *A
      w/ Power Slide Door
      *B
      w/o Power Slide Door
      *a
      Lock
      *b
      Unlock
      *c
      Component without harness connected
      (Door Lock Actuator Assembly)


INSPECT REAR DOOR LOCK ACTUATOR ASSEMBLY RH

  1. B321157E02
    Inspect the slide door lock assembly RH.

    1. Apply battery voltage and check operation of the door lock actuator.

      Standard:
      w/ Power Slide Door 
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 3
      Lock
      Battery positive (+) → Terminal 3
      Battery negative (-) → Terminal 2
      Unlock
      w/o Power Slide Door 
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Lock
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      Unlock

  1. w/ Smart Entry and Start System:
    Check the operation of the door unlock detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      Battery positive (+) → Terminal 1 (*A)
      Battery negative (-) → Terminal 4 (*A)
      Locks
      10 kΩ or higher
      Battery positive (+) → Terminal 1 (*A)
      Battery negative (-) → Terminal 4 (*A)
      Unlocks
      Below 1 Ω

      Text in Illustration 
      *A
      w/ Power Slide Door
      *B
      w/o Power Slide Door
      *a
      Lock
      *b
      Unlock
      *c
      Component without harness connected
      (Door Lock Actuator Assembly)

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →