2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT ACCELERATOR PEDAL ROD ASSEMBLY
  1. Inspect the voltage.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Select the menu items: Powertrain / Engine and ECT / Data List / Accel Sensor Pos No. 1, Accel Sensor Pos No. 2.

    5. When depressing or releasing the accelerator pedal, check that the values of Accel Sensor Pos No. 1 and Accel Sensor Pos No. 2 are within the specification.

      Accel Sensor Pos No. 1 Standard Voltage:
      Condition
      Specified Condition
      Accelerator pedal is released
      0.5 to 1.1 V
      Accelerator pedal is depressed
      2.6 to 4.5 V

      Accel Sensor Pos No. 2 Standard Voltage:
      Condition
      Specified Condition
      Accelerator pedal is released
      1.2 to 2.0 V
      Accelerator pedal is depressed
      3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal rod assembly, wire harness and ECM.

← COMPONENTS (from Oct 2014)REMOVAL (Oct 2014 – Dec 2014) →