2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT ENGINE COOLANT TEMPERATURE SENSOR
  1. Partially immerse the engine coolant temperature sensor in water and warm up the water.

  1. Measure the resistance according to the value(s) in the table below.

    A224572E05

    Text in Illustration 
    *a
    Component without harness connected
    (Engine Coolant Temperature Sensor)
    *b
    Resistance
    *c
    Temperature
    *d
    Acceptable Range

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    2.32 to 2.59 kΩ
    80°C (176°F)
    0.310 to 0.326 kΩ

    CAUTION:
    1. Do not put your hands in the water warmed up during the inspection.
    2. Touching the hot water may result in burns.

    NOTICE:
    When checking the engine coolant temperature sensor in water, do not allow water to contact the terminals. After completing the check, dry the engine coolant temperature sensor.

    If the result is not as specified, replace the engine coolant temperature sensor.

← REMOVAL (from Jan 2017)INSTALLATION (from Jan 2017) →