2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017


1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap sub-assembly while the engine assembly and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock.

  1. Loosen the radiator drain cock plug.

    A397672E03

    Text in Illustration 
    *1
    Bleeder Plug
    *2
    Radiator Cap Sub-assembly
    *3
    Radiator Reserve Tank Assembly
    *4
    Cylinder Block Drain Cock Plug
    *5
    Radiator Drain Cock Plug
    -
    -

  1. Remove the radiator cap sub-assembly.

  1. Loosen the cylinder block drain cock plug, and drain the engine coolant.

  1. Tighten the radiator drain cock plug.

  1. Tighten the cylinder block drain cock plug.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Disconnect the hose from the radiator drain cock.


2. DISCONNECT VANE PUMP ASSEMBLY

  1. A398405
    Remove the 2 bolt and disconnect the vane pump assembly from the generator bracket.


3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

  1. A346005
    Disconnect the engine coolant temperature sensor connector.

  1. A346049E01
    Using SST, remove the engine coolant temperature sensor and gasket from the cylinder head sub-assembly.
    SST
    09817-33191  

← COMPONENTS (from Jan 2017)INSPECTION (from Jan 2017) →