2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT FINS FOR BLOCKAGE

  1. A115059
    If the fins are clogged, wash them with water or a steam cleaner and dry with compressed air.

    NOTICE:
    1. To avoid damaging the fins, the injection direction should be at right angles to the core surface.
    1. If the steam cleaner is too close to the core, there is a possibility of damaging the fins, so maintain the following injection distances.
      Standard Injection Distance
      Injection Pressure
      Specified Condition
      2942 to 4903 kPa (30 to 50 kgf*cm2, 427 to 711 psi)
      300 mm (11.8 in)
      4903 to 7845 kPa (50 to 80 kgf*cm2, 711 to 1138 psi)
      500 mm (19.7 in)
    2. If the fins are bent, straighten them with a screwdriver or pliers.
    3. Do not expose electronic components to water.

  1. Dry the fins with compressed air.


INSPECT RADIATOR RESERVE TANK CAP SUB-ASSEMBLY

  1. A215769E06
    Measure the valve opening pressure.
    Text in IllustrationĀ 
    *a
    O-Ring
    *b
    Rubber Packing

    1. If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.

    2. Check that the O-ring is not deformed, cracked or swollen.

    3. Apply engine coolant to the O-ring and rubber packing before using a radiator cap tester.

    4. B008802E20
      When using the radiator cap tester, tilt it more than 30 degrees.
      Text in IllustrationĀ 
      *1
      Radiator reserve tank cap sub-assembly
      *a
      Radiator cap tester
      *b
      30° or more

    5. Pump the radiator cap tester several times and check the maximum pressure*.

      Pump speed:
      1 pump per second

      *: Even if the cap cannot maintain the maximum pressure, it is not a defect.

      Standard Judgment Criterion:
      Item
      Specified Condition
      Standard value
      (for brand-new cap)
      93 to 123 kPa (1.0 to 1.3 kgf*cm2, 13.5 to 18 psi)
      Minimum standard value (for used cap)
      79 kPa (0.8 kgf*cm2, 11.4 psi)

      If the maximum pressure is less than the minimum standard value, replace the radiator cap sub-assembly.

← COMPONENTS (from Jan 2017)REMOVAL (from Jan 2017) →