To avoid the danger of being burned, do not remove the reservoir cap while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.
Loosen the radiator drain plug.
Remove the reservoir cap.
Loosen the cylinder block drain plug and drain the coolant.
Tighten the radiator drain plug.
Tighten the cylinder block drain plug.
Torque:
13 N*m{
130 kgf*cm
, 9 ft.*lbf
}
2.
DRAIN ENGINE OIL
3.
REMOVE FRONT SEAT ASSEMBLY RH
Move the front seat assembly fully forward.
Remove the 2 bolts on the rear side of the seat.
Move the front seat assembly to the rearmost position.
Remove the 2 bolts on the front side of the seat.
Move the front seat assembly to the center of the seat slide rail. Set the seatback in the upright position.
Disconnect the front seat inner belt assembly connector.
Remove the front seat assembly.
4.
REMOVE FRONT DOOR SCUFF PLATE RH
5.
REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
Turn back the carpet, and remove the engine service hole cover sub-assembly.
6.
REMOVE INTAKE AIR CONNECTOR SUB-ASSEMBLY
Disconnect the ventilation hose.
Disconnect the turbo pressure sensor connector.
Remove the bolt, 3 nuts, intake air connector and gasket.
7.
REMOVE INTAKE AIR CONNECTOR BRACKET
Remove the 2 bolts and intake air connector bracket.
8.
REMOVE OIL LEVEL GAGE SUB-ASSEMBLY
9.
REMOVE OIL LEVEL GAGE GUIDE
Remove the 2 bolts, oil level gage and oil level gage guide.
10.
REMOVE VANE PUMP V BELT
Loosen the bolt A and nut B, and remove the V belt.
11.
REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1 (w/ Air Conditioning System)
Loosen the nut A and bolt B, and remove the V belt.
12.
REMOVE FAN & GENERATOR V BELT (w/o Air Conditioning)
Loosen the bolts A and B, and remove the V belt.
13.
REMOVE FAN & GENERATOR V BELT (w/ Air Conditioning System)
Loosen the bolts A and B.
Loosen the adjusting bolt C, and remove the V belt.
14.
SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (w/ Air Conditioning System)