2014-2019 Hiace · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014

HINT:
  1. Thoroughly clean all parts to be assembled.
  2. Before installing the parts, apply fresh engine oil to all sliding and rotating surfaces.
  3. Replace all gaskets and oil seals with new ones.


1. REMOVE VALVE LIFTER
  1. Remove the 16 valve lifters.

    HINT:
    Arrange the 16 valve lifters in the correct order.


2. REMOVE INTAKE VALVE

A060282E01
  1. Using SST, compress the compression spring and remove the 2 valve spring retainer locks.

    SST
    09202-70020   (09202-00020)

  1. Remove the spring retainer, compression spring, valve and spring seat.

    HINT:
    Arrange the valves, compression springs, spring seats and spring retainers in the correct order.


3. REMOVE EXHAUST VALVE

A060276E01
  1. Using SST, compress the compression spring and remove the 2 valve spring retainer locks.

    SST
    09202-70020   (09202-00020)

  1. Remove the spring retainer, compression spring, valve and spring seat.

    HINT:
    Arrange the valves, compression springs, spring seats and spring retainers in the correct order.


4. REMOVE VALVE STEM OIL O SEAL OR RING

A058955E01
  1. Using needle-nose pliers, remove the 16 oil seals.


5. REMOVE SEMICIRCULAR PLUG

6. REMOVE NO. 1 WITH HEAD STRAIGHT SCREW PLUG

  1. A142379
    Using a 6 mm hexagon wrench, remove the 4 straight screw plugs.


7. REMOVE RING PIN

  1. A156655
    Remove the 4 ring pins from the cylinder head.


8. REMOVE STUD BOLT

  1. Remove the 15 stud bolts from the cylinder head.

    A142375E01

← REMOVAL (from Dec 2017)INSPECTION (from Oct 2014) →