2014-2019 Hiace · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL STUD BOLT

A142376E01

Torque:
5.0 N*m{ 51 kgf*cm , 44 in.*lbf } for A and E
7.0 N*m{ 71 kgf*cm , 62 in.*lbf } for B
15 N*m{ 153 kgf*cm , 11 ft.*lbf } for C
20 N*m{ 204 kgf*cm , 15 ft.*lbf } for D


2. INSTALL RING PIN

A156656E01

3. INSTALL NO. 1 WITH HEAD STRAIGHT SCREW PLUG
  1. Apply adhesive to the threads of the screw plugs.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. A142379
    Using a 6 mm hexagon wrench, install the screw plugs.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }


4. INSTALL SEMICIRCULAR PLUG
  1. Remove any old packing (FIPG) material.

  1. Apply seal packing to the semicircular plug as shown in the illustration.

    Seal packing:
    Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent

    NOTICE:
    1. The semicircular plug must be installed within 3 minutes of applying the seal packing.
    2. Prevent seal packing from being stuck to the camshaft thrust groove.
    3. Prevent seal packing from contacting the camshaft thrust groove.

  1. Install the semicircular plug onto the cylinder head.

    A061555E01


5. INSTALL VALVE STEM OIL O SEAL OR RING

A059919E01
  1. Using SST, push in a new oil seal.

    SST
    09201-41020  


6. INSTALL INTAKE VALVE

A058114E01
  1. Install the valve, spring seat, compression spring and spring retainer.

  1. Using SST, compress the compression spring and place the 2 valve spring retainer locks around the valve stem.

    SST
    09202-70020   (09202-00020)

  1. A060277E01
    Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.

    NOTICE:
    Be careful not to damage the valve stem tip.


7. INSTALL EXHAUST VALVE

A058113E01
  1. Install the valve, spring seat, compression spring and spring retainer.

  1. Using SST, compress the compression spring and place the 2 valve spring retainer locks around the valve stem.

    SST
    09202-70020   (09202-00020)

  1. A059917E01
    Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.

    NOTICE:
    Be careful not to damage the valve stem tip.


8. INSTALL VALVE LIFTER
  1. Install the valve lifter.

  1. Check that the valve lifter rotates smoothly by hand.

← REPLACEMENT (from Oct 2014)INSTALLATION (Oct 2014 – Dec 2014) →