DISASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1.
REMOVE STARTER YOKE ASSEMBLY |
 |
Remove the screw and terminal 50 wire.
- Remove the nut and disconnect the terminal C wire.
Remove the 2 crews and O-rings, and pull out the starter yoke assembly with the armature assembly.
| 2.
REMOVE MAGNET STARTER SWITCH ASSEMBLY |
 |
- Remove the 2 screws and magnet starter switch assembly.
Remove the return spring.
- Remove the following parts from the starter housing.
(1)
|
Starter clutch sub-assembly
|
(2)
|
Starter armature pinion
|
(3)
|
Starter idler pinion
|
(4)
|
Retainer
|
(5)
|
Clutch roller
|
- Using a magnetic finger, remove the steel ball.
| 3.
REMOVE STARTER BRUSH HOLDER ASSEMBLY |
 |
- Using a screwdriver, hold the spring back and disconnect the brush.
Disconnect the 4 brushes and remove the brush holder assembly.
| 4.
REMOVE STARTER ARMATURE ASSEMBLY |
 |
- Using a plastic hammer, tap the end of the starter yoke assembly and remove the armature assembly.