2014-2019 Hiace · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL STARTER ARMATURE ASSEMBLY

  1. P004699E01
    Using a press, install the armature assembly.


2. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. ST00096E01
    Align the claw of the brush holder with the claw groove of the starter yoke assembly.

  1. Place the brush holder on the starter yoke assembly.

  1. N000562E02
    Using a screwdriver, hold the brush spring back.

  1. Connect the brush onto the brush holder.

  1. Connect the 4 brushes.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.

  1. Install a new O-ring to the groove of the starter yoke.


3. INSTALL MAGNET STARTER SWITCH ASSEMBLY
  1. Apply grease to the steel ball, and return spring.

  1. Install the steel ball into the starter clutch sub-assembly hole.

  1. Insert the return spring into the magnet starter switch hole.

  1. B000464E03
    Place the following parts in position on the starter housing.
    (1)
    Starter clutch sub-assembly
    (2)
    Starter armature pinion
    (3)
    Starter idler pinion
    (4)
    Retainer
    (5)
    Clutch roller

  1. B000462E01
    Install the starter housing to the magnet switch assembly with the 2 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY
  1. Install a 2 new O-rings to the groove of the starter yoke assembly.

  1. Align the claws of the brush holder with the grooves of the magnet starter switch.

  1. Install the starter yoke assembly with the armature assembly.

  1. B000463E01
    Align the punch mark of the starter yoke with the line of the magnet starter switch.

  1. B000461E02
    Install the 2 through bolts.

    Torque:
    12.7 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Connect the terminal C wire with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Oct 2014)INSTALLATION (from Oct 2014) →