Connect a positive (+) lead from battery to the terminal of the shift solenoid valve S1 connector, and a negative (-) lead to the shift solenoid valve S1 body, and check the operation of the valve.
OK:
The valve moves and makes an operating sound.
If the result is not as specified, replace the shift solenoid valve S1.
INSPECT SHIFT SOLENOID VALVE S2
Measure the resistance according to the value(s) in the table below.
Connect a positive (+) lead from battery to the terminal of the shift solenoid valve S2 connector, and a negative (-) lead to the shift solenoid valve S2 body, and check the operation of the valve.
OK:
The valve moves and makes an operating sound.
If the result is not as specified, replace the shift solenoid valve S2.
INSPECT SHIFT SOLENOID VALVE SLT
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
5.0 to 5.6 Ω
Text in Illustration
*a
Component without harness connected (Shift Solenoid Valve SLT)
Connect the positive (+) lead with a 21 W bulb from the battery to terminal 2 and the negative (-) lead to terminal 1 of the shift solenoid valve SLT connector and check the operation of the valve.
OK:
The valve moves and makes an operating sound.
If the result is not as specified, replace the shift solenoid valve SLT.
INSPECT SHIFT SOLENOID VALVE SL
w/o Flex Lock-up:
Measure the resistance according to the value(s) in the table below.
Connect a positive (+) lead from battery to the terminal of the shift solenoid valve SL connector, and a negative (-) lead to the shift solenoid valve SL body, and check the operation of the valve.
OK:
The valve moves and makes an operating sound.
If the result is not as specified, replace the shift solenoid valve SL.
INSPECT SHIFT SOLENOID VALVE SLU
w/ Flex Lock-up:
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
5.1 to 5.5 Ω
Text in Illustration
*a
Component without harness connected (Shift Solenoid Valve SLU)
Connect the positive (+) lead with a 21 W bulb from the battery to terminal 1 and the negative (-) lead to terminal 2 of the shift solenoid valve SLU connector and check the operation of the valve.
OK:
The valve moves and makes an operating sound.
If the result is not as specified, replace the shift solenoid valve SLU.