2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL INPUT SHAFT FRONT BEARING

  1. C086534
    Using SST and a press, press in a new input shaft front bearing.
    SST
    09316-60011   (09316-00031)

  1. D033850
    Select a snap ring that will allow minimum amount of axial play.

    Standard clearance:
    0.1 mm (0.0039 in.) or less

    Front bearing shaft snap ring thickness 
    Mark
    Thickness: mm (in.)
    0
    2.05 to 2.10 (0.0807 to 0.0827)
    1
    2.10 to 2.15 (0.0827 to 0.0847)
    2
    2.15 to 2.20 (0.0847 to 0.0866)
    3
    2.20 to 2.25 (0.0866 to 0.0886)
    4
    2.25 to 2.30 (0.0886 to 0.0906)
    5
    2.30 to 2.35 (0.0906 to 0.0925)

  1. D033851
    Using a snap ring expander, install the snap ring.


2. INSTALL INPUT SHAFT BEARING

  1. C086536
    Coat the 13 input shaft bearings with MP grease, install them to the input shaft.


3. INSTALL SYNCHRONIZER RING NO.2

  1. C067214
    Coat the synchronizer ring No.2 with gear oil, and install it to the input shaft.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →