2014-2019 Hiace · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT SYNCHRONIZER RING NO.2

  1. C067457
    Apply gear oil to the input shaft cone. Press the synchronizer ring against the input shaft cone and check that the synchronizer ring does not turn in the directions shown in the illustration.
    If it turns, replace the synchronizer ring.

  1. C067456
    Using a feeler gauge, measure the clearance between the synchronizer ring No .2 back and input shaft spline end.

    Standard:
    1.0 to 2.0 mm (0.0394 to 0.0787 in.)

    If the clearance is not as specified, replace the synchronizer ring No.2.

    NOTICE:
    Ensure the fine lapping compound is completely washed off after rubbing.

← DISASSEMBLY (from Oct 2014)REASSEMBLY (from Oct 2014) →