2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL COUNTER GEAR FRONT BEARING OR ROLLER

  1. C086513E01
    Using SST and a press, press in a new front bearing to the counter gear.
    SST
    09515-10010  

  1. C086514
    Select a snap ring that will allow the minimum amount of axial play.

    Standard clearance:
    0.1 mm (0.0039 in.) or less

    Counter gear front bearing snap ring No.1 thickness: 
    Mark
    Thickness: mm (in.)
    1
    2.05 to 2.10 (0.0807 to 0.0827)
    2
    2.10 to 2.15 (0.0827 to 0.0847)
    3
    2.15 to 2.20 (0.0847 to 0.0866)
    4
    2.20 to 2.25 (0.0866 to 0.0886)
    5
    2.25 to 2.30 (0.0886 to 0.0906)
    6
    2.30 to 2.35 (0.0906 to 0.0925)

  1. C086511
    Using a snap ring expander, install the snap ring.


2. INSTALL TRANSMISSION HUB SLEEVE NO.3

  1. D033572
    Coat the counter shaft 5th gear with gear oil.

  1. Install the hub sleeve No.3 and 2 synchromesh shifting keys No.3 to the 5th gear.

    HINT:
    Be sure to set the hub sleeve No. 3 and synchromesh shifting keys No.3 to the 5th gear in the correct direction.

  1. Install the key spring (C spring) and key spring (return spring) to the 5th gear.

  1. D033581
    Using a snap ring expander, install the snap ring to the 5th gear.


3. INSTALL COUNTER 5TH GEAR BEARING

  1. D033580
    Coat the 5th gear bearing with gear oil, and install it to the 5th gear.


4. INSPECT COUNTER SHAFT 5TH GEAR RADIAL CLEARANCE

  1. C086503
    Install the 5th gear thrust washer lock ball, the 5th gear thrust washer, and the 5th gear to the counter gear.

  1. Using a dial indicator, measure the counter shaft 5th gear radial clearance.

    Standard clearance:
    0.008 to 0.034 mm(0.0003 to 0.00134 in.)

    If the clearance is not as specified, replace the 5th gear bearing.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →