2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL SHIFT LEVER SHAFT OIL SEAL

  1. C114278E01
    Using SST and a hammer, install a new oil seal until its surface is flush with the housing end surface.
    SST
    09550-10012   (09252-10010)

  1. Apply MP grease to the oil seal lip.


2. INSTALL SHIFT LEVER NO.2 SHAFT OIL SEAL

  1. C114279E01
    Using SST and a hammer, install a new oil seal until its surface is flush with the housing end surface.
    SST
    09550-10012   (09252-10010)

  1. Apply MP grease to the oil seal lip.


3. INSTALL REVERSE RESTRICT PIN NO.1

  1. C086530
    Coat the reverse restrict pin No.1 with gear oil.

  1. Install the spring to the reverse restrict pin No.1.

  1. Install the reverse restrict pin No.1 and spring to the shift lever shaft housing.


4. INSTALL REVERSE RESTRICT PIN SLOTTED SPRING PIN

  1. C086701
    Using a pin punch (5 mm) and a hammer, install the slotted spring pin to the shift lever shaft housing.


5. INSTALL SELECT SPRING SEAT NO.1

  1. C086528
    Coat the select spring seat No.1 with gear oil.

  1. Install the select spring seat No.1 and spring to the shift lever shaft housing.


6. INSTALL SHIFT AND SELECT LEVER SHAFT

  1. C086527
    Coat the shift and select lever shaft with gear oil.

  1. Install the shift and select lever shaft to the shift lever shaft housing.


7. INSTALL SHIFT LEVER SHAFT SET SLOTTED SPRING PIN

  1. C086526
    Using a pin punch (5 mm) and a hammer, install the shift lever shaft set slotted pin to the shift and select lever shaft.


8. INSTALL SHIFT LEVER BOOT

  1. C086525
    Install the shift lever boot to the shift lever shaft housing.


9. INSTALL SHIFT OUTER LEVER NO.1

  1. C112981
    Install the shift outer lever No.1 to the shift and select lever shaft.


10. INSTALL SHIFT OUTER LEVER LOCK PIN

  1. C086522
    Install the shift outer lever lock pin to the shift outer lever No.1 with the nut.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }


11. INSTALL SELECT LEVER SHAFT SUB-ASSEMBLY

  1. C086521
    Coat the select lever shaft with gear oil, and install it to the shift lever shaft housing.


12. INSTALL SELECT OUTER LEVER

  1. C112978
    Install the select outer lever and washer to the select lever shaft.


13. INSTALL LEVER LOCK PIN NO.2

  1. C112976
    Install the shift lever lock pin No.2 to the select outer lever with the nut.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }

← DISASSEMBLY (from Oct 2014)PROBLEM SYMPTOMS TABLE (Oct 2014 – Mar 2016) →