2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


INSPECT STARTER ARMATURE ASSEMBLY

  1. A073983E02
    Using an ohmmeter, check that there is continuity between the segments of the commutator.
    If there is no continuity between any segment, replace the starter armature.

  1. A073984E02
    Using an ohmmeter, check the resistance between the commutator and armature coil core.

    Standard resistance:
    10 kΩ or higher

    If the result is not as specified, replace the starter armature.

  1. Check the commutator surface for dirt or burn.
    If the surface is dirty or burnt, smooth the surface with 400-grit sandpaper.

  1. A058584E01
    Using vernier calipers, measure the commutator length.

    Standard length:
    3.1 mm (0.122 in.)

    Maximum length:
    3.8 mm (0.150 in.)

    If the length is greater than the maximum, replace the starter armature assembly.


INSPECT STARTER COMMUTATOR END FRAME ASSEMBLY

  1. A076677E01
    Using vernier calipers, measure the brush holder length.

    Standard length:
    9.0 mm (0.354 in.)

    Minimum length:
    4.0 mm (0.158 in.)

    If the length is less than the minimum, replace the starter commutator end frame assembly.

  1. A076436
    Using an ohmmeter, measure the resistance between the positive (+) and negative (-) brushes.

    Standard resistance:
    10 kΩ or higher

    If the resistance is not as specified, replace the starter commutator end frame assembly.


INSPECT STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
  1. Check the gear teeth on the planet gears, internal gear and starter clutch for wear or damage.
    If any of the gears is damaged, replace the starter center bearing clutch sub-assembly

  1. Check the starter clutch pinion gear.

    1. A073987E01
      Turn the clutch pinion gear clockwise and check that it turns freely. Try to turn the clutch pinion gear counterclockwise and check that it locks.
      If necessary, replace the starter clutch.


INSPECT REPAIR SERVICE STARTER KIT

  1. A058586
    Check the plunger.

    1. Push in the plunger and check that it returns quickly to its original position.
      If necessary, replace the repair service starter kit.

  1. G037611E01
    Using an ohmmeter, measure the resistance between terminals 50 and C.

    Standard resistance:
    1 Ω or lower

    If the result is not as specified, replace the repair service starter kit.

  1. G037612E01
    Using an ohmmeter, measure the resistance between terminal 50 and the switch body.

    Standard resistance:
    2 Ωor lower

    If the result is not as specified, replace the repair service starter kit.

← DISASSEMBLY (from Jan 2015)INSPECTION (from Jan 2015) →