2014-2019 Hiace · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL STARTER ARMATURE ASSEMBLY

  1. A071182
    Install the starter armature to the starter yoke.


2. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Place the brush holder assembly on the starter yoke assembly.

  1. A112474
    Using a screwdriver, hold the brush spring back.

  1. Connect the brush into the brush holder.

  1. Connect the 4 brushes.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.

  1. A102628
    Install the commutator end frame with the 2 screws.

    Torque:
    3.6 N*m{ 37 kgf*cm , 32 in.*lbf }


3. INSTALL MAGNET STARTER SWITCH ASSEMBLY
  1. Apply grease to the steel ball, and return spring.

  1. Install the steel ball into the magnet starter switch hole.

  1. Insert the return spring into the magnet starter switch hole.

  1. A112471E04
    Place the following parts in position on the starter housing.
    (1)
    Starter clutch sub-assembly
    (2)
    Starter idler pinion
    (3)
    Retainer
    (4)
    Clutch roller
    (5)
    Plate washer

  1. A112470
    Install the starter housing to the magnet magnet switch assembly with the 3 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY
  1. Install the felt washer to the starter armature.

  1. A112486E01
    Install the starter yoke to the starter switch.

    HINT:
    Align the claw of the starter yoke with the groove of the starter switch.

  1. A112469
    Tighten the 2 through bolts.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. Connect the terminal C wire with the nut.

    Torque:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }

← INSPECTION (from Oct 2014)INSTALLATION (from Oct 2014) →