2014-2019 Hiace · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL OIL PUMP DRIVE GEAR

  1. A057459E01
    Place the timing gear case on wooden blocks.

    NOTICE:
    Do not damage the timing pointer.

  1. Insert the drive and driven gears into the timing gear case with the marks facing the oil pump cover side.

  1. A057460E01
    Apply adhesive to 2 or 3 threads of the screws.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. Install the oil pump cover with the 8 screws.

    Torque:
    10 N*m{ 105 kgf*cm , 7 ft.*lbf }


2. INSTALL OIL PUMP RELIEF VALVE
  1. Insert the relief valve and spring into the installation hole of the timing gear case.

  1. A057453E02
    Using a 12 mm hexagon wrench, install a new gasket and the plug.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }


3. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

  1. A057640E02
    Using SST and a hammer, tap in a new oil seal to the depth of 0.5 mm (0.020 in.) from the oil pump case edge.
    SST
    09214-60010  

  1. Apply MP grease to the oil seal lip.

← INSPECTION (from Oct 2014)INSTALLATION (Oct 2014 – Dec 2016) →