INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT CLUTCH DISC ASSEMBLY |
Using vernier calipers, measure the rivet head depth.

- Minimum rivet depth:
- 0.3 mm (0.012 in.)
Install the clutch disc assembly to the transmission unit.

- NOTICE:
- Take care not to insert the clutch disc assembly in the wrong direction.
Using a dial indicator, check the clutch disc assembly runout.
- Maximum runout:
- 0.8 mm (0.031 in.)
| INSPECT CLUTCH COVER ASSEMBLY |
Using vernier calipers, inspect the diaphragm spring for the depth and width of wear.

- Maximum:
A (Depth):
B (Width):
0.5 mm (0.020 in.)
6.0 mm (0.236 in.)
| INSPECT FLYWHEEL SUB-ASSEMBLY |
Using a dial indicator, inspect the flywheel sub-assembly runout.

- Maximum runout:
- 0.1 mm (0.004 in.)
| INSPECT CLUTCH RELEASE BEARING ASSEMBLY |
Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.

Inspect the clutch release bearing assembly for damage or wear.
