INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT HAZARD WARNING SWITCH |
Inspect the hazard warning switch operation.

Remove the hazard warning switch.
Measure the resistance according to the value(s) in the table below.
- Resistance:
Tester connection
Switch operation
Specified condition
3 - 4
OFF
10 kΩ or higher
3 - 4
ON
Below 1 Ω
Inspect the illumination operation.
Apply battery voltage to the hazard warning switch connector.
- OK:
Measurement condition
Specified condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Illumination comes on
