2014-2019 Hiace · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Oct 2014

HINT:
Use the same procedure for RHD and LHD vehicles.


INSPECT NO. 1 ROOM LIGHT SWITCH ASSEMBLY

E289584E02
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      9 - 6
      No. 1 room light switch assembly OFF
      10 kΩ or higher
      No. 1 room light switch assembly ON
      Below 1 Ω

      If the result is not as specified, replace the No. 1 room light switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Room Light Switch Assembly)

  1. E289584E01
    Check the illumination.

    1. Apply battery voltage to the connector and check the illumination condition.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 8 (ILL+)
      Battery negative (-) → Terminal 7 (ILL-)
      Illuminates

      If the result is not as specified, replace the No. 1 room light switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Room Light Switch Assembly)

← INSPECTION (from Oct 2014)ON-VEHICLE INSPECTION (from Oct 2014) →