2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Jan 2017


1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor at an engine rpm of approximately 1,000 for 5 to 6 minutes to circulate the refrigerant and collect compressor oil remaining in each component into the cooler compressor as much as possible.

  1. Stop the engine.

  1. Using SST, let the refrigerant gas out.

    SST
    07110-58060   (07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)


2. REMOVE V-RIBBED BELT

  1. A396825E01
    While turning the V-ribbed belt tensioner assembly clockwise, align the service holes of the V-ribbed belt tensioner assembly, and then insert a pin with a diameter of 5.0 mm (0.197 in.) into the service holes to fix the V-ribbed belt tensioner assembly in place.
    Text in Illustration 
    *a
    Service Hole
    *b
    Pin

  1. Remove the fan and generator V belt.


3. REMOVE GENERATOR ASSEMBLY
(Click here)

4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

  1. E359952
    Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler compressor assembly.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


5. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE

  1. E359953
    Remove the bolt and disconnect the No. 1 cooler refrigerant suction hose from the cooler compressor assembly.

  1. Remove the O-ring from the No. 1 cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


6. REMOVE COOLER COMPRESSOR ASSEMBLY

E359954
  1. Detach the clamp and disconnect the connector.

  1. E359955
    Remove the 2 bolts and 2 nuts.

  1. E359956
    Using an E8 "TORX" socket wrench, remove the 2 stud bolts and cooler compressor assembly.

← COMPONENTS (from Jan 2017)DISASSEMBLY (from Jan 2017) →