DISASSEMBLY
Removal / installation · Vehicles built from Jan 2017
| 1. REMOVE COOLER BRACKET |
![]() ![]() |
Detach the clamp.
Remove the screw and cooler bracket.
| 2. REMOVE MAGNET CLUTCH ASSEMBLY |
![]() ![]() |
Clamp the cooler compressor assembly in a vise.
Using SST, hold the magnet clutch hub.
- SST
- 09985-00270
Remove the bolt, magnet clutch hub and magnet clutch washer(s).
- HINT:
- There is no set number of magnet clutch washers since they are used for adjusting.
Using a snap ring expander, remove the snap ring and magnet clutch rotor.

- NOTICE:
- Do not damage the seal cover of the bearing when removing the snap ring.
Disconnect the connector.
Using a snap ring expander, remove the snap ring and magnet clutch stator.



