2014-2019 Hiace · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. REMOVE SELECT OUTER LEVER LOCK PIN

  1. C114252
    Loosen the nut of the select outer lever lock pin until the top of the nut becomes flush with the end of the lock pin.

  1. C114245
    Using a brass bar and a hammer, disengage the select outer lever lock pin.

  1. Remove the nut, washer and select outer lever lock pin from the shift lever shaft housing assembly.


2. REMOVE SELECT OUTER LEVER

  1. C114246
    Remove the select outer lever and washer from the select lever shaft sub-assembly.


3. REMOVE SELECT LEVER SHAFT SUB-ASSEMBLY

  1. D026097
    Remove the select lever shaft sub-assembly from the shift lever shaft housing.


4. REMOVE LEVER LOCK PIN NO.2

  1. C114251
    Loosen the nut of the lever lock pin No.2 until the top of the nut becomes flush with the end of the lock pin.

  1. C114247
    Using a brass bar and a hammer, disengage the lever lock pin No.2.

  1. Remove the nut, washer and lever lock pin No.2 from the shift lever shaft housing assembly.


5. REMOVE SHIFT OUTER LEVER NO.1

  1. C114248
    Remove the shift outer lever No.1 from the shift and select lever shaft.


6. REMOVE SHIFT LEVER BOOT

  1. D026100
    Remove the shift lever boot from the shift lever shaft housing.


7. REMOVE SHIFT AND SELECT LEVER SHAFT

  1. C114274
    Using a pin punch (5 mm) and a hammer, remove the shift lever shaft set slotted pin.

    NOTICE:
    Be careful not to damage the shift and select lever.

  1. C114275E01
    Pull out the shift and select lever shaft from the shift lever shaft housing.


8. REMOVE SHIFT AND SELECT LEVER

  1. C114253
    Remove the shift and select lever, select spring seat No.1 and spring from the shift lever shaft housing.


9. REMOVE REVERSE RESTRICT PIN SLOTTED SPRING PIN

  1. D026104
    Using a hammer, drive a screw extractor into the reverse restrict pin slotted spring pin.

  1. Pull out the reverse restrict pin slotted spring pin from the shift lever shaft housing.


10. REMOVE REVERSE RESTRICT PIN NO.1

  1. D026105
    Remove the reverse restrict pin No.1 and compression spring from the shift lever shaft housing.

  1. Remove the compression spring from the reverse restrict pin No.1.


11. REMOVE SHIFT LEVER NO.2 SHAFT OIL SEAL

  1. C114272
    Using a screwdriver with its tip taped, remove the shift lever No.2 shaft oil seal from the shift lever shaft housing.

    NOTICE:
    Be careful not to damage the shift lever shaft housing.


12. REMOVE SHIFT LEVER SHAFT OIL SEAL

  1. C114273
    Using a screwdriver with its tip taped, remove the shift lever shaft oil seal from the shift lever shaft housing.

    NOTICE:
    Be careful not to damage the shift lever shaft housing.

← COMPONENTS (from Oct 2014)REASSEMBLY (from Oct 2014) →