2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL SHIFT LEVER SHAFT OIL SEAL

  1. C114276E01
    Using SST, install a new oil seal until its surface is flush with the housing end surface.
    SST
    09950-60010   (09951-00290)
    09950-70010   (09951-07100)

  1. Apply MP grease to the oil seal lip.


2. INSTALL SHIFT LEVER NO.2 SHAFT OIL SEAL

  1. C114277E01
    Using SST, install a new oil seal until its surface is flush with the housing end surface.
    SST
    09950-60010   (09951-00190)
    09950-70010   (09951-07100)

  1. Apply MP grease to the oil seal lip.


3. INSTALL REVERSE RESTRICT PIN NO.1

  1. D026105
    Coat the reverse restrict pin No.1 with gear oil.

  1. Install the spring to the reverse restrict pin No.1.

  1. Install the reverse restrict pin No.1 and spring to the shift lever shaft housing.


4. INSTALL REVERSE RESTRICT PIN SLOTTED SPRING PIN

  1. D026110
    Using a pin punch (5 mm) and a hammer, install the slotted spring pin to the shift lever shaft housing.


5. INSTALL SHIFT AND SELECT LEVER

  1. C114253
    Coat the select spring seat No.1 with gear oil.

  1. Install the shift and select lever, select spring seat No.1 and spring to the shift lever shaft housing.


6. INSTALL SHIFT AND SELECT LEVER SHAFT

  1. C114275E02
    Coat the shift and select lever shaft with gear oil.

  1. Install the shift and select lever shaft to the shift lever shaft housing.

  1. C114274
    Using a pin punch (5 mm) and a hammer, install the shift lever shaft set slotted pin to the shift and select lever shaft.


7. INSTALL SHIFT LEVER BOOT

  1. D026100
    Install the shift lever boot to the shift lever shaft housing.


8. INSTALL SHIFT OUTER LEVER NO.1

  1. C114248
    Install the shift outer lever No.1 to the shift and select lever shaft.


9. INSTALL LEVER LOCK PIN NO.2

  1. C114251
    Install the lever lock pin No.2 and nut to the shift outer lever No.1.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }


10. INSTALL SELECT LEVER SHAFT SUB-ASSEMBLY

  1. D026097
    Coat the select lever shaft sub-assembly with gear oil, and install it to the shift lever shaft housing.


11. INSTALL SELECT OUTER LEVER

  1. C114246
    Install the select outer lever and washer to the select lever shaft sub-assembly.


12. INSTALL SELECT OUTER LEVER LOCK PIN

  1. C114252
    Install the select outer lever lock pin and nut to the select outer lever.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

← DISASSEMBLY (from Oct 2014)PROBLEM SYMPTOMS TABLE (from Oct 2014) →