2014-2019 Hiace · Service Manual SUSPENSION & AXLE

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built Jan 2017 – Nov 2017

Versions by build date: Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are output by the blinking of the tire pressure warning light.

WIRING DIAGRAM

C171960E13

HINT:
When each warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.


INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DLC3 - ECU AND BODY GROUND)
  1. Turn the ignition switch off.

  1. Disconnect the tire T38 pressure warning ECU and receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H23-13 (TC) - T38-3 (TC)
    Always
    Below 1 Ω
    H23-13 (TC) or T38-3 (TC) - Body ground
    Always
    10 kΩ or higher
    H23-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU
OK

CHECK PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← ECU Power Source Circuit (from Dec 2017)TC and CG Terminal Circuit (from Dec 2017) →