ECU Power Source Circuit
Circuit diagnosis · Vehicles built from Dec 2017
Versions by build date: Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
This is the power source for the tire pressure warning ECU and receiver.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
- It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
- When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
- HINT:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (ECU - BATTERY AND BODY GROUND) |
Turn the ignition switch off.
Disconnect the T38 tire pressure warning ECU and receiver connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
T38-1 (IG) - Body ground
Ignition switch ON
10 to 16 V
Ignition switch off
Below 1 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
T38-12 (GND) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)
|
|
||||
| OK | ||
| ||
