INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT HEATER SWITCH |
![]() ![]() |
Remove the heater switch and disconnect the connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester connection
Switch position
Specified condition
1 (TAIL) - 2 (L1)
Always
Below 1 Ω
3 (S+) - 4 (S-)
OFF → ON
10 kΩ or higher → Below 1 Ω
6 (IND) - 5 (E)
Always
Below 1 Ω


