2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1451 Compressor Solenoid Circuit

Diagnostic trouble codes · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

DESCRIPTION

In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier.
Based on this signal, the compressor changes the degree of refrigerant compression.
DTC Code
DTC Detection Condition
Trouble Area
B1451
Open or short in solenoid of externally changeable compressor circuit
  1. Compressor assembly with pulley
  2. Harness and connector
  3. Air conditioning amplifier

WIRING DIAGRAM

E214514E06

INSPECTION PROCEDURE


1. READ VALUE USING GTS (REGULATOR CONTROL CURRENT)
  1. Use the Data List to check if the compressor assembly with pulley is functioning properly (Click here).

    Air Conditioner:
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Regulator Control Current
    Regulator control current /
    Min.: 0 A
    Max.: 0.997 A
    Value changes between 0 A and 0.997 A in accordance with compressor assembly with pulley operation
    -

    OK:
    The display is as specified in the normal condition column.

    Result 
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE)
    B
    OK (When troubleshooting according to the DTC)
    C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
A


2. INSPECT COMPRESSOR ASSEMBLY WITH PULLEY
  1. Remove the compressor assembly with pulley (Click here).

  1. Inspect the compressor assembly with pulley (Click here).



NG
REPLACE COMPRESSOR WITH PULLEY ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - COMPRESSOR ASSEMBLY WITH PULLEY)
  1. Disconnect the H18 air conditioning amplifier connector.

  1. Disconnect the D13 compressor assembly with pulley connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    H18-19 (MGC) - D13-2
    Always
    Below 1 Ω
    H18-19 (MGC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (COMPRESSOR ASSEMBLY WITH PULLEY - BODY GROUND)
E269947E01
  1. Disconnect the D13 compressor assembly with pulley connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D13-1 - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Compressor Assembly with Pulley)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)


← B1423 Pressure Sensor Circuit (from Jan 2017)B1451 Compressor Solenoid Circuit (Jan 2015 – Mar 2016) →