2014-2019 Hiace · Service Manual BRAKE

TS and CG Terminal Circuit

Circuit diagnosis · Vehicles built Jan 2017 – Nov 2017

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017

DESCRIPTION

The signal check circuit detects trouble in the sensor or switch signal which cannot be detected by the DTC check.
Connecting terminals TS and CG of the DLC3 starts the check.

WIRING DIAGRAM

C173350E03

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).


1. CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR ASSEMBLY - TS of DLC3)
  1. Turn the ignition switch off.

  1. Disconnect the B92 skid control ECU (brake actuator assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B92-24 (TS) - H23-12 (TS)
    Always
    Below 1 Ω
    B92-24 (TS) or H23-12 (TS) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

  1. C245481E22
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H23-4 (CG) - Body ground
    Always
    Below 1 Ω

    Text in Illustration  
    *a
    Front view of DLC3



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (TS of DLC3 - BODY GROUND)

  1. C245481E23
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H23-12 (TS) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration  
    *a
    Front view of DLC3



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← TS and CG Terminal Circuit (Apr 2016 – Dec 2016)VSC OFF Switch Circuit (Jan 2015 – Mar 2016) →