2014-2019 Hiace · Service Manual BRAKE

Slip Indicator Light does not Come ON

Circuit diagnosis · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

Refer to Slip Indicator Light Remains ON (Click here).

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
CHECK CAN COMMUNICATION SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING GTS (SLIP INDICATOR LIGHT)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

  1. According to the display on the GTS, perform the Active Test.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Slip Indicator Light
    Slip indicator light
    Indicator light ON/OFF
    Observe combination meter assembly
    Vehicle condition: Vehicle stopped

  1. When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Slip Indicator Light
    Slip Indicator Light / ON or OFF
    ON: Indicator light on
    OFF: Indicator light off
    -

    Result:
    Result
    Proceed to
    Slip indicator light in the Data List turns ON/OFF using the Active Test
    A
    Slip indicator light in the Data List does not change using the Active Test
    B



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A


3. INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Perform Active Test of the combination meter assembly using the GTS (Click here).

  1. Check the combination meter assembly.

    OK:
    The slip indicator light turns on or off in accordance with the GTS.



NG
INSPECT METER / GAUGE SYSTEM (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← Slip Indicator Light does not Come ON (Jan 2015 – Mar 2016)Slip Indicator Light does not Come ON (Jan 2017 – Nov 2017) →