U0101 Lost Communication with TCM
Diagnostic trouble codes · Vehicles built Jan 2015 – Mar 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
The ECM (engine control unit) communicates with the TCM (transmission control ECU) through the Controller Area Network (CAN).If there is a problem with this communication, the ECM stores a DTC.
| DTC Detection Drive Pattern |
DTC Detection Condition |
Trouble Area |
| Ignition switch to ON for 3 seconds |
Both conditions are met for 1.25 seconds (1 trip detection logic):
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1. CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC U0101) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
Result Result
Proceed to
DTC U0101 is output
A
DTC U0101 and other DTCs are output
B
- HINT:
- If any DTCs other than U0101 are output, troubleshoot those DTCs first.
|
|
||||
| A | |
| 2. INSPECT TCM POWER SOURCE CIRCUIT (POWER SOURCE AND BODY GROUND) |
Disconnect the TCM connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
O3-5 (BATT) - O1-1 (E1)
Ignition switch ON
11 to 14 V
Text in Illustration *a
Rear view of wire harness connector
(to TCM)
Reconnect the TCM connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (ECM - TCM) |
Disconnect the TCM connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
B88-4 (CAN+) - O3-21 (CAN+)
Always
Below 1 Ω
B88-5 (CAN-) - O3-20 (CAN-)
Always
Below 1 Ω
B88-4 (CAN+) or O3-21 (CAN+) - Body ground or other terminals
Always
1 MΩ or higher
B88-5 (CAN-) or O3-20 (CAN-) - Body ground or other terminals
Always
1 MΩ or higher
Reconnect the TCM connector.
Reconnect the ECM connector.
|
|
||||
| OK | |
| 4. REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 5. CHECK WHETHER DTC OUTPUT RECURS (DTC U0101) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
Result Result
Proceed to
DTC is not output
A
DTC U0101 is output
B
|
|
||||
| A | ||
| ||
