U0101 Lost Communication with TCM
Diagnostic trouble codes · Vehicles built Dec 2015 – Mar 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
The ECM intercommunicates with the TCM through the Controller Area Network (CAN).If there is a problem in this intercommunication, the ECM sets the DTC.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| U0101 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC U0101) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
Result Result
Proceed to
U0101 is output
A
U0101 and other DTCs are output
B
- HINT:
- If any DTCs other than U0101 are output, troubleshoot those DTCs first.
|
|
||||
| A | |
| 2. INSPECT TCM |
Disconnect the TCM connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
O3-5 (BATT) - O1-1 (E1)
Ignition switch ON
11 to 14 V
Reconnect the TCM connector.
| *a |
Rear view of wire harness connector (to TCM) |
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (TCM - ECM) |
Disconnect the ECM connector.
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
D98-40 (CAN+) - O3-21 (CAN+)
Always
Below 1 Ω
D98-63 (CAN-) - O3-20 (CAN-)
Always
Below 1 Ω
D98-40 (CAN+) or O3-21 (CAN+) - Body ground
Always
10 kΩ or higher
D98-63 (CAN-) or O3-20 (CAN-) - Body ground
Always
10 kΩ or higher
Reconnect the TCM connector.
Reconnect the ECM connector.
|
|
||||
| OK | |
| 4. REPLACE ECM |
| NEXT | |
| 5. CHECK WHETHER DTC OUTPUT RECURS (DTC U0101) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
Result Result
Proceed to
No DTC is output
A
U0101 is output
B
|
|
||||
| A | ||
| ||
