2014-2019 Hiace · Service Manual STEERING

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

HINT:
  1. Use the following procedures to troubleshoot the steering lock system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the problem (Click here).

    NEXT

    3.CHECK BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      HINT:
      A simple method to determine whether the battery is depleted is to operate the horn.

    NEXT

    4.CHECK DTC*
    1. Check for DTCs and make a note of any codes that are output (Click here).

      HINT:
      When DTCs indicating CAN and/or LIN communication system malfunctions are output, repair the CAN and/or LIN communication systems before performing diagnosis (for CAN: Click here, and/or for LIN: Click here).


      Result:
      Result
      Proceed to
      DTC is not output. (Problem symptom cannot be confirmed or reproduced.)
      A
      DTC is not output. (Problem symptom can be confirmed and reproduced.)
      B
      Steering lock system DTC is output.
      C

      HINT:
      1. When steering lock system DTCs are output, refer to Diagnostic Trouble Code Chart (Click here).
      2. The steering lock system does not store past DTCs.


    B.

    C.
    A

    5.SYMPTOM SIMULATION
    1. Proceed to How to Proceed with Troubleshooting (Click here).

    NEXT

    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table.
      A
      Fault is listed in Problem Symptoms Table.
      B


    B.
    A

    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Proceed to Data List / Active Test (Click here).

    2. Proceed to Terminals of ECU (Click here).

    NEXT

    8.CIRCUIT INSPECTION*
      NEXT

      9.REPAIR OR REPLACE
        NEXT

        10.CHECK DTC AGAIN*
        1. Clear the DTCs (Click here).

        2. Check for DTCs and make a note of any codes that are output (Click here).

          HINT:
          Perform the DTC output confirmation operation.


          Result:
          Result
          Proceed to
          DTC is not output.
          A
          Steering lock system DTC is output.
          B


        B.
        A

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Jan 2015 – Mar 2016)HOW TO PROCEED WITH TROUBLESHOOTING (Jan 2017 – Nov 2017) →