2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1422 Compressor Lock Sensor Circuit

Diagnostic trouble codes · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

SYSTEM DESCRIPTION

The ECM sends the engine speed signal to the air conditioning amplifier assembly via CAN communication.
The air conditioning amplifier assembly reads the difference between compressor speed and engine speed. When the difference becomes too large, the air conditioning amplifier assembly determines that the cooler compressor assembly is locked and turns the magnet clutch assembly off.
DTC Code
DTC Detection Condition
Trouble Area
B1422
Open or short in the compressor lock sensor circuit.
  1. Cooler compressor assembly
  2. Compressor drive belt
  3. Harness or connector
  4. Air conditioning amplifier assembly
  5. CAN communication system

WIRING DIAGRAM

E193114E21

INSPECTION PROCEDURE

HINT:
As DTC B1422 is also output when the compressor drive belt is damaged or loose, inspect the belt before performing troubleshooting.


1. CHECK CAN COMMUNICATION SYSTEM
  1. Use the GTS to check if the CAN communication system is functioning normally.

    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2. INSPECT COOLER COMPRESSOR ASSEMBLY
  1. Remove the cooler compressor assembly (A/C lock sensor) (Click here).

  1. Inspect the cooler compressor assembly (A/C lock sensor) (Click here).



NG
REPLACE COOLER COMPRESSOR ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - A/C LOCK SENSOR)
  1. Disconnect the H18 air conditioning amplifier assembly connector.

  1. Disconnect the D14 cooler compressor assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H18-28 (LOCK) - D14-1
    Always
    Below 1 Ω
    H18-31 (SG-1) - D14-2
    Always
    Below 1 Ω
    H18-28 (LOCK) - Body ground
    Always
    10 kΩ or higher
    H18-31 (SG-1) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (When troubleshooting according to problem symptoms table)
    A
    OK (When troubleshooting according to the DTC)
    B
    NG
    C



B
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← B1422 Compressor Lock Sensor Circuit (Jan 2015 – Mar 2016)B1422 Compressor Lock Sensor Circuit (from Jan 2017) →