TERMINALS OF ECU
System information · Vehicles built from Oct 2014
| CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |


Disconnect the B75 certification ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
If the result is not as specified, there may be a malfunction on the wire harness side.Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
B75-10 (E) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
B75-1 (+B) - B75-10 (E)
L - W-B
Battery power supply
Always
11 to 14 V
| CHECK ID CODE BOX (IMMOBILISER CODE ECU) |


Disconnect the H81 ID code box connector.
Measure the resistance and voltage according to the value(s) in the table below.
If the result is not as specified, there may be a malfunction on the wire harness side.Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
H81-5 (GND) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
H81-1 (+B) - H81-5 (GND)
W - W-B
Battery power supply
Always
11 to 14 V
| CHECK STEERING LOCK ACTUATOR ASSEMBLY |
![]() ![]() |
Disconnect the H80 steering lock actuator assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
If the result is not as specified, there may be a malfunction on the wire harness side.Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
H80-1 (GND) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
H80-6 (IG2) - H80-1 (GND)
B - W-B
IG signal
Engine switch off
Below 1 V
Engine switch on (IG)
11 to 14 V
H80-7 (B) - H80-1 (GND)
W - W-B
Battery power supply
Always
11 to 14 V
