INSTALLATION
Removal / installation · Vehicles built Jan 2015 – Mar 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
| 1. INSTALL CRANKSHAFT POSITION SENSOR |
![]() ![]() |
Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
Install the crankshaft position sensor with the bolt.

- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- Do not crack or jam the O-ring when installing the crankshaft position sensor.
Connect the 3 wire harness clamps.
Connect the crankshaft position sensor to the No. 1 vacuum pipe.

Connect the crankshaft position sensor connector.
| 2. INSTALL VANE PUMP OIL RESERVOIR ASSEMBLY |
Connect the vane pump oil reservoir with the 2 bolts.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
| 4. PERFORM INITIALIZATION |
Perform initialization procedures (Click here).
- NOTICE:
- Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.

