2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT COOLING FAN SWITCH
  1. Partially immerse the cooling fan switch in water and warm up the water.

  1. Measure the resistance according to the value(s) in the table below.

    A398804E01

    Text in Illustration 
    *a
    Component without harness connected
    (Cooling Fan Switch)
    *b
    Resistance
    *c
    Temperature
    *d
    Acceptable Range

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    2.32 to 2.59 kΩ
    80°C (176°F)
    0.310 to 0.326 kΩ

    CAUTION:
    1. Do not put your hands in the water warmed up during the inspection.
    2. Touching the hot water may result in burns.

    NOTICE:
    When checking the cooling fan switch in water, do not allow water to contact the terminals. After completing the check, dry the engine coolant temperature sensor.

    If the result is not as specified, replace the cooling fan switch.

← REMOVAL (from Jan 2017)INSTALLATION (from Jan 2017) →