2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017


1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap sub-assembly while the engine assembly and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock.

  1. Loosen the radiator drain cock plug.

    A397672E03

    Text in Illustration 
    *1
    Bleeder Plug
    *2
    Radiator Cap Sub-assembly
    *3
    Radiator Reserve Tank Assembly
    *4
    Cylinder Block Drain Cock Plug
    *5
    Radiator Drain Cock Plug
    -
    -

  1. Remove the radiator cap sub-assembly.

  1. Loosen the cylinder block drain cock plug, and drain the engine coolant.

  1. Tighten the radiator drain cock plug.

  1. Tighten the cylinder block drain cock plug.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Disconnect the hose from the radiator drain cock.


2. REMOVE COOLING FAN SWITCH

  1. A142536
    Disconnect the cooling fan switch connector.

  1. Using a 19 mm deep socket wrench, remove the cooling fan switch and gasket.

← COMPONENTS (from Jan 2017)INSPECTION (from Jan 2017) →