2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT COOLING FAN RELAY (FAN NO. 1)

A301376E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the resistance is not as specified, replace the cooling fan relay.


INSPECT NO. 2 COOLING FAN RELAY (FAN NO. 2)

A301376E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the resistance is not as specified, replace the No. 2 cooling fan relay.

← INSTALLATION (from Jan 2017)COMPONENTS (from Jan 2017) →