Power Slide Door Warning Buzzer LH Circuit
Circuit diagnosis · Vehicles built from Oct 2014
DESCRIPTION
The power slide door system uses a warning buzzer built on the power slide door ECU LH. The power slide door warning buzzer emits different beeping patterns depending on the type of operation being performed (open, close, switch or inside/outside handle).WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR WARNING BUZZER LH - POWER SLIDE DOOR ECU LH) |
Disconnect the q2 connector from the power slide door warning buzzer LH.

Disconnect the q4 connector from the power slide door ECU LH.
Measure the resistance.
- Standard resistance:
Tester Connection
Condition
Specified Condition
q4-1 (BZR+) - q2-1 (BZR+)
Always
Below 1 Ω
q2-2 (BZR-) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
