2014-2019 Hiace · Service Manual BODY

Power Slide Door Warning Buzzer RH Circuit

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

The power slide door system uses a buzzer built on the door control relay assembly. The buzzer emits different beeping patterns depending on the type of operation being performed (open, close, switch or inside/outside handle).

WIRING DIAGRAM

(Click here)

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (BUZZER - DOOR CONTROL RELAY ASSEMBLY)
  1. Disconnect the I2 buzzer connector.

  1. Disconnect the I4 door control relay assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I2-1 - I4-1 (BZR)
    Always
    Below 1 Ω
    I2-2 - Body ground
    Always
    Below 1 Ω
    I2-1 or I4-1 (BZR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DOOR CONTROL RELAY ASSEMBLY (Click here)


← Power Slide Door Warning Buzzer LH Circuit (from Oct 2014)PRECAUTION (from Oct 2014) →