REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE SLIDE DOOR WINDOW GARNISH LH
|
 |
- Disengage the 4 clips and remove the slide door window garnish.
| 3.
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
|
 |
- Using "TORX" socket wrench T25, remove the 2 screws.
- Disengage the claw and 19 clips, and remove the rear door trim board.
| 4.
REMOVE REAR DOOR SCUFF PLATE LH
|
 |
- Disengage the claw and 12 clips.
Disconnect the connector and remove the rear door scuff plate.
| 5.
REMOVE SIDE STEP REAR SUPPORT LH
|
 |
Remove the 3 bolts and the side step rear support.
| 6.
REMOVE DOOR CONTROL RELAY ASSEMBLY
|
 |
Disconnect the connectors.
Remove the bolt and the door control relay.
| 7.
REMOVE REAR NO. 2 DOOR WIRE
|
 |
- Remove the bolt.
- Disconnect the connector from the vehicle.
- Remove the 4 bolts, and then disengage the 4 clips.
Disconnect the connector of the door, and remove the rear No. 2 door wire.
- NOTICE:
- Do not put anything on the rear No. 2 door wire after removal.
| 8.
REMOVE SLIDE DOOR SERVICE HOLE COVER LH
|
 |
- Disengage the clamp.
Disconnect the cable from the slide door lock remote control.
Remove the slide door service hole cover.
| 9.
REMOVE POWER SLIDE DOOR TOUCH SENSOR |
 |
Disconnect the connector.
Using "TORX" socket wrench T25, remove the 6 screws.
Remove the 3 bolts.
Disengage the 2 clips and the power slide door touch sensor.