2014-2019 Hiace · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL POWER SLIDE DOOR MOTOR ASSEMBLY

  1. B102095
    Install the power slide door motor with the 10 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

  1. B164199
    Install the 2 grommets.

  1. Install the slide door lower roller assembly LH onto the belt bracket of the power slide door motor assembly.

  1. B102804
    Install the slide door lower rail plate with the bolt.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }

  1. B102094
    Tighten the slide door lower roller assembly LH and belt bracket with the 2 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }


2. INSTALL REAR NO. 2 DOOR WIRE

  1. B102794
    Make sure that the wire harness is not twisted, and tighten the bolts after the clamp is fully secured by turning it in the direction indicated by the arrow mark.

  1. Connect the connector.


3. INSTALL DOOR CONTROL RELAY ASSEMBLY

B164189
  1. Install the door control relay with the bolt.

  1. Connect the connectors.


4. INSTALL SIDE STEP REAR SUPPORT LH

B164188
  1. Install the side step rear support with the 3 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }


5. INSTALL REAR DOOR SCUFF PLATE LH

  1. B164187
    Connect the connector.

  1. Engage the claw and 12 clips and install the rear door scuff plate.


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →