2014-2019 Hiace · Service Manual BODY

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT POWER SLIDE DOOR MOTOR ASSEMBLY

  1. E105250E03
    Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals of connector A.

      Standard resistance:
      Tester Connection
      Specified Condition
      q5-4 (CL-) - q5-5 (CL+)
      Below 3.6 Ω

      If the result is not as specified, replace the power slide door motor.

    2. Apply battery voltage to the power slide door motor and check the resistance of the power slide door motor.

      Standard resistance:
      Measurement Condition
      Tester Connection
      Specified Condition
      Battery positive (+) → q1-3 (DSV)
      Battery negative (-) → q1-1 (DSG)
      q1-2 (DS2) - q1-1 (DSG)
      Below 1 Ω
      Battery Disconnected
      q1-2 (DS2) - q1-1 (DSG)
      10 kΩ or higher
      Battery positive (+) → q1-3 (DSV)
      Battery negative (-) → q1-1 (DSG)
      q1-4 (DS1) - q1-1 (DSG)
      Below 1 Ω
      Battery Disconnected
      q1-4 (DS1) - q1-1 (DSG)
      10 kΩ or higher

      If the result is not as specified, replace the power slide door motor.

  1. Check the operation.

    B102923E03

    1. Apply battery voltage to the power slide door motor and check the operation of the power slide door motor.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → q5-2 (SD+)
      Battery negative (-) → q5-1 (SD-)
      Low- speed open operation (clockwise)
      Battery positive (+) → q5-1 (SD-)
      Battery negative (-) → q5-2 (SD+)
      Low- speed close operation (counterclockwise)

      If the result is not as specified, replace the power slide door motor.

← REMOVAL (from Oct 2014)INSTALLATION (from Oct 2014) →