2014-2019 Hiace · Service Manual BODY

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT SLIDE DOOR LOCK RELEASE MOTOR

  1. B103311E02
    Check the operation of the slide door lock release motor.

    1. Disconnect the connector.

    2. Apply battery voltage to the slide door lock release motor and check the operation of the slide door lock release motor.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 6
      Battery negative (-) → Terminal 5
      Motor gear rotates clockwise
      Battery positive (+) → Terminal 5
      Battery negative (-) → Terminal 6
      Motor gear rotates counterclockwise

      If the result is not as specified, replace the slide door lock release motor.

  1. B164222E01
    Check the resistance of the initial position switch and full switch.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard resistance:
      Switch
      Cam Position
      Tester Connection
      Specified Condition
      Initial Position Switch
      A
      1 - 2
      Below 1 Ω
      Initial Position Switch
      Any position other than A
      1 - 2
      10 kΩ or higher
      Full Switch
      B
      3 - 4
      Below 1 Ω
      Full Switch
      Any position other than B
      3 - 4
      10 kΩ or higher

      If the result is not as specified, replace the slide door lock release motor.

← REMOVAL (from Oct 2014)INSTALLATION (from Oct 2014) →