2014-2019 Hiace · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE SLIDE DOOR WINDOW GARNISH LH

  1. B164184
    Disengage the 4 clips and remove the slide door window garnish.


3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B164185
    Using "TORX" socket wrench T25, remove the 2 screws.

  1. B164186
    Disengage the claw and 19 clips, and remove the rear door trim board.


4. REMOVE REAR DOOR SCUFF PLATE LH

  1. B164187
    Disengage the claw and 12 clips.

  1. Disconnect the connector and remove the rear door scuff plate.


5. REMOVE SIDE STEP REAR SUPPORT LH

B164188
  1. Remove the 3 bolts and the side step rear support.


6. REMOVE DOOR CONTROL RELAY ASSEMBLY

B164189
  1. Disconnect the connectors.

  1. Remove the bolt and the door control relay.


7. REMOVE REAR NO. 2 DOOR WIRE

  1. B164190
    Remove the bolt.

  1. B102795
    Disconnect the connector from the vehicle.

  1. B164191
    Remove the 4 bolts, and then disengage the 4 clips.

  1. Disconnect the connector of the door, and remove the rear No. 2 door wire.

    NOTICE:
    Do not put anything on the rear No. 2 door wire after removal.


8. REMOVE SLIDE DOOR SERVICE HOLE COVER LH

  1. B164192
    Disengage the clamp.

  1. Disconnect the cable from the slide door lock remote control.

  1. Remove the slide door service hole cover.


9. REMOVE SLIDE DOOR LOCK RELEASE MOTOR

B164203
  1. Disconnect the connector and cable.

  1. Disconnect the link.

  1. Remove the 3 bolts and the slide door lock release motor.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →