2014-2019 Hiace · Service Manual ENGINE

P060B Internal Control Module A/D Processing Performance

Diagnostic trouble codes · Vehicles built Jan 2015 – Mar 2016

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

DESCRIPTION

This DTC is stored when a communication error occurs in the ECM.
DTC No.
DTC Detection Condition
Trouble Area
P060B
There is an ECM main CPU communication error (1 trip detection logic).
  1. ECM
  2. Knock sensor

CONFIRMATION DRIVING PATTERN

  1. Turn the ignition switch off.
  2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
  3. Connect the cable to the negative (-) battery terminal.
  4. Turn the ignition switch to ON and wait for 16 seconds or more.

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Clear the DTCs (Click here).

  1. Turn the GTS off.

  1. Turn the ignition switch off.

  1. Disconnect the GTS.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and turn the GTS on.

  1. Wait 16 seconds or more.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Check for DTCs.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC P060B is output
    B
    DTC P060B and P0327 or P0328 are output
    C



B
REPLACE ECM (Click here)

C
GO TO DTC P0327 OR P0328 (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P060A Internal Control Module Monitoring Processor Performance (from Jan 2017)P060B Internal Control Module A/D Processing Performance (Apr 2016 – Dec 2016) →