2014-2019 Hiace · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL VACUUM PUMP BEARING

  1. C111354
    Using a press, press in a new vacuum pump bearing to the vacuum pump shaft.


2. INSTALL VACUUM PUMP SHAFT

  1. C111355E01
    Using SST and a press, press the vacuum pump shaft into the vacuum pump housing.
    SST
    09608-04031  

  1. C060758E01
    Using snap ring pliers, install a new snap ring.

    NOTICE:
    Make sure that the snap ring is firmly installed in the groove.


3. INSTALL VACUUM PUMP GEAR
  1. Install the woodruff key and vacuum pump gear to the vacuum pump shaft with the gear lock nut.

  1. C095668
    Fix the vacuum pump gear in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Fully tighten the gear lock nut.

    Torque:
    110 N*m{ 1125 kgf*cm , 82 ft.*lbf }


4. INSTALL VACUUM PUMP BLADE
  1. Apply engine oil to the vacuum pump rotor.

  1. C111356E01
    Install the vacuum pump rotor to the vacuum pump shaft.

  1. Apply engine oil to 5 new vacuum pump blades.

  1. Install the 5 vacuum pump blades with the round end facing outward.

    NOTICE:
    1. Make sure that the vacuum pump blades are flush with the rotor surface.
    2. Install the vacuum pump blades with round end touching the inner surface of the vacuum pump housing.


5. INSTALL VACUUM PUMP END COVER
  1. Place the vacuum pump in a vise between aluminum plates.

  1. Apply engine oil to 2 new O-rings.

  1. Install the 2 O-rings.

  1. Install the vacuum pump end cover and temporarily install the 3 bolts.

  1. C095657
    Using a 5 mm pin punch and hammer, tap in the 2 straight pins.

  1. C061438
    Fix the vacuum pump in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Fully tighten the 3 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }


6. INSTALL CHECK VALVE SUB-ASSEMBLY

  1. C061437
    Install a new gasket and the check valve.

    Torque:
    74 N*m{ 749 kgf*cm , 54 ft.*lbf }


7. INSTALL VACUUM PUMP UNION

  1. C148742E01
    Install 2 new gaskets and vacuum pump union with the union bolt.

    Torque:
    14 N*m{ 140 kgf*cm , 10 ft.*lbf }

    NOTICE:
    Check that the stopper of the vacuum pump union is securely held on the vacuum pump.


8. INSPECT VACUUM PUMP

  1. C095565
    Turn the vacuum pump gear counter-clockwise (left-hand turn, viewed from the gear side) and check for improper movement or torque change.

← INSPECTION (from Oct 2014)INSTALLATION (from Oct 2014) →